This adds support to the Babel protocol for the RTT extension specified in
draft-ietf-babel-rtt-extension. While this extension is not yet at the RFC
stage, it is one of the more useful extensions to Babel[0], so it seems
worth having in Bird as well.
The extension adds timestamps to Hello and IHU TLVs and uses these to
compute an RTT to each neighbour. An extra per-neighbour cost is then
computed from the RTT based on a minimum and maximum interval and cost
value specified in the configuration. The primary use case for this is
improving routing in a geographically distributed tunnel-based overlay
network.
The implementation follows the babeld implementation when picking constants
and default configuration values. It also uses the same RTT smoothing
algorithm as babeld, and follows it in adding a new 'tunnel' interface type
which enables RTT by default.
[0] https://alioth-lists.debian.net/pipermail/babel-users/2022-April/003932.html
Signed-off-by: Toke Høiland-Jørgensen <toke@toke.dk>
Add a current_time_now() function which gets an immediate monotonic
timestamp instead of using the cached value from the event loop. This is
useful for callers that need precise times, such as the Babel RTT
measurement code.
Signed-off-by: Toke Høiland-Jørgensen <toke@toke.dk>
The Babel seqno request code keeps track of which seqno requests are
outstanding for a neighbour by putting them onto a per-neighbour list. When
reusing a seqno request, it will try to remove this node, but if the seqno
request in question was a multicast request with no neighbour attached this
will result in a crash because it tries to remove a list node that wasn't
added to any list.
Fix this by making the list remove conditional. Also add a check so that
seqno requests are only reused if the neighbour also matches, allowing
multiple outstanding requests for the same router ID.
Fixes: ebd5751cde ("Babel: Seqno requests are properly decoupled from neighbors when the underlying interface disappears")
Reported-by: Stefan Haller <stefan.haller@stha.de>
Signed-off-by: Toke Høiland-Jørgensen <toke@toke.dk>
When shutting down a Babel instance we send a wildcard retraction to make
sure all peers can quickly switch to other route origins. Add another small
optimisation borrowed from babeld: sending a Hello message (along with the
retraction) with a very low interval.
This will cause neighbours to modify their expiry timers for the node's
state to quickly time it out, thus conserving resources in the network.
When BIRD was munmapping too many pages, it sometimes aborted, saying
that munmap failed with "Not enough memory" as the address space was
getting more and more fragmented.
There is a workaround in place, simply keeping that page for future use,
yet it has never been compiled in because I somehow forgot to include
errno.h. And because I also thought that somebody may have ENOMEM not
defined (why?!), there was a check which quietly omitted that
workaround.
Anyway, ENOMEM is POSIX. It's an utter nonsense to check for its
existence. If it doesn't exist, something is broken.
Add BFD protocol option 'strict bind' to use separate listening socket
for each BFD interface bound to its address instead of using shared
listening sockets.
There were several requests to allow use of 240.0.0.0/4 as a private
range, and Linux kernel already allows such routes, so perhaps we can
allow that too.
Thanks to Vincent Bernat and others for suggestion and patches.
When birdc is called with a command as an argument, it should set exit
status to non-zero when BIRD replied with an error reply code.
Thanks to Vincent Bernat and others for suggestion.
A recent change in Babel causes ifaces to disappear after
reconfiguration. The patch fixes that.
Thanks to Johannes Kimmel for an insightful bugreport.
Alignment of slabs should be at least sizeof(ptr) to avoid unaligned
pointers in slab structures. Fixme: Use proper way to choose alignment
for internal allocators.
After switching to 16-way tries, trie format ignored unaligned / internal
prefixes and only reported the primary prefix of a trie node.
Fix trie format by showing internal prefixes based on the 'local' bitmask
of a node. Also do basic (intra-node) reconstruction of prefix patterns
by finding common subtrees in 'local' bitmask.
In future, we could improve that by doing inter-node reconstruction, so
prefixes entered as one pattern for a subtree (e.g. 192.168.0.0/18+)
would be reported as such, like with aligned prefixes.
The prune loop may may rebuild the prefix trie and therefore invalidate
walk state for asynchronous walks (used in 'show route in' cmd). Fix it
by adding locking that keeps the old trie in memory until current walks
are done.
In future this could be improved by rebuilding trie walk states (by
lookup for last found prefix) after the prefix trie rebuild.
When rtable is pruned and network fib nodes are removed, we also need to
prune prefix trie. Unfortunately, rebuilding prefix trie takes long time
(got about 400 ms for 1M networks), so must not be atomic, we have to
rebuild a new trie while current one is still active. That may require
some considerable amount of temporary memory, so we do that only if
we expect significant trie size reduction.
Implement flowspec validation procedure as described in RFC 8955 sec. 6
and RFC 9117. The Validation procedure enforces that only routers in the
forwarding path for a network can originate flowspec rules for that
network.
The patch adds new mechanism for tracking inter-table dependencies, which
is necessary as the flowspec validation depends on IP routes, and flowspec
rules must be revalidated when best IP routes change.
The validation procedure is disabled by default and requires that
relevant IP table uses trie, as it uses interval queries for subnets.
When output of 'show route' command was generated, the net_format() was
called for each network prematurely, even if the result was not needed.
Fix the code to call net_format() only when needed. This makes queries
that process many networks but show only few (e.g. 'show route where ..',
or 'show route count') much faster (like 5x - 10x faster).
Attach a prefix trie to IP/VPN/ROA tables. Use it for net_route() and
net_roa_check(). This leads to 3-5x speedups for IPv4 and 5-10x
speedup for IPv6 of these calls.
TODO:
- Rebuild the trie during rt_prune_table()
- Better way to avoid trie_add_prefix() in net_get() for existing tables
- Make it configurable (?)
One of previous commits added error logging of invalid routes. This
also inadvertently caused error logging of route loops, which should
be ignored silently. Fix that.
Most error messages in attribute processing are in rx/decode step and
these use L_REMOTE log class. But there are few that are in tx/export
step and these should use L_ERR log class.
Use tx-specific macro (REJECT()) in tx/export code and rename field
err_withdraw to err_reject in struct bgp_export_state to ensure that
appropriate error reporting macros are called in proper contexts.
+ ubuntu:21.10 added into the pipeline,
- ubuntu:20.10 removed from the pipeline,
+ misc/docker/ubuntu-21.10-amd64/Dockerfile added,
- misc/docker/ubuntu-20.10-amd64/Dockerfile removed.
Add option 'netlink rx buffer' to specify netlink socket receive buffer
size. Uses SO_RCVBUFFORCE, so it can override rmem_max limit.
Thanks to Trisha Biswas and Michal for the original patches.
Add strict checking for netlink KRT dumps to avoid PMTU cache records
from FNHE table dump along with KRT.
Linux Kernel added FNHE table dump to the netlink API in patch:
8d3b68cd37.1561131177.git.sbrivio@redhat.com/
Therefore, since Linux 5.3 these route cache entries are dumped together
with regular routes during periodic KRT scans, which in some cases may be
huge amount of useless data. This can be avoided by using strict checking
for netlink dumps:
https://lore.kernel.org/netdev/20181008031644.15989-1-dsahern@kernel.org/
The patch mitigates the risk of receiving unknown and potentially large
number of FNHE records that would block BIRD I/O in each sync. There is a
known issue caused by the GRE tunnels on Linux that seems to be creating
one FNHE record for each destination IP address that is routed through
the tunnel, even when the PMTU equals to GRE interface MTU.
Thanks to Tomas Hlavacek for the original patch.
Kernel uses cloned routes to keep route cache entries, but reports them
together with regular routes. They were skipped implicitly as they
do not have rtm_protocol filled. Add explicit check for cloned flag
and skip such routes explicitly.
Also, improve debug logs of skipped routes.
Add option to socket interface for nonlocal binding, i.e. binding to an
IP address that is not present on interfaces. This behaviour is enabled
when SKF_FREEBIND socket flag is set. For Linux systems, it is
implemented by IP_FREEBIND socket flag.
Minor changes done by commiter.
Currently, BIRD ignores dead routes to consider them absent. But it also
ignores its own routes and thus it can not correctly manage such routes
in some cases. This patch makes an exception for routes with proto bird
when ignoring dead routes, so they can be properly updated or removed.
Thanks to Alexander Zubkov for the original patch.
Lexer expression for bytestring was too loose, accepting also
full-length IPv6 addresses. It should be restricted such that
colon is used between every byte or never.
Fix the regex and also add some test cases for it.
Thanks to Alexander Zubkov for the bugreport
