The old code stored route verdicts and temporary routes directly in
rtable. The new code do not store received routes (it immediately
compares them with exported routes and resolves conflicts) and uses
internal bitmap to keep track of which routes were received and which
needs to be reinstalled.
By not putting 'invalid' temporary routes to rtable, we keep rtable
in consistent state, therefore scan no longer needs to be atomic
operation and could be splitted to multiple events.
Do not apply dynamic type check for second argument of AND/OR, as it is
not evaluated immediately like regular argument would be.
Thanks to Mikael for the bugreport.
Initial parsing of test.conf must be done directly in filter_test main,
while reconfiguration is handled as a regular test. Also fix several
minor issues in test code.
Channel currently does not have independent pool and uses protocol pool,
which is freed when protocol changes state to down, while channel is
still in flushing. Move some some cleanup code to channel_do_flush()
so it is done before freeing of protocol pool.
Use a hierarchical bitmap in a routing table to assign ids to routes, and
then use bitmaps (indexed by route id) in channels to keep track whether
routes were exported. This avoids unreliable and inefficient re-evaluation
of filters for old routes in order to determine whether they were exported.
Basic bitmap is obvious. Hierarchical bitmap is structure of several
bitmaps, where higher levels are conjunctions of intervals on level
below, allowing for efficient lookup of first unset bit.
Continuation lines may use short form (with space instead of message
number), but this should not be done when previous line is final.
Thanks to Kenth Eriksson for the bugreport and analysis.
During NLRI parsing of IPv6 Flowspec, dst prefix was not properly
extracted from NLRI, therefore a received flow was stored in a different
position in flowspec routing table, and was not reachable by command
'show route <flow>'.
Add proper prefix part accessors to flowspec code and use them from BGP
NLRI parsing code.
Thanks to Alex D. for the bugreport.
Accept RTA_VIA attribute in all cases. The old code always used
RTA_GATEWAY for IPv4 / IPv6 and RTA_VIA for MPLS. The new code uses
RTA_VIA in cases where AF of network and AF of nexthop differs.
This is optional check described in RFC 4271. Although this can be also
done by filters, it is widely implemented option in BGP implementations.
Thanks to Eugene Bogomazov for the original patch.
We use constant promotion from IPv4 to Router-ID values, as they have
same literals. Instead of ad-hoc code in filter instructions, add
constant promotion code to parse-time typecheck code.
Most expressions can be type-validated in parse time. It is not
strong enough to eliminate runtime checks, but at least one gets
errors immediately during reconfigure.
Transitive extended communities should be removed on external sessions,
the old code them in all cases.
Thanks to Jean-Daniel Pauget for the original patch.
Names read from texfiles in /etc/iproute2/* are normalized by replacing
non-alphanumeric chars with underscore. The patch fixes handling of
uppercase letters, which were handled as non-alphanumberic.
Thanks to Igor Gavrilov for the bugreport.
Change of some options requires route refresh, but when import table is
active, channel reload is done from it instead of doing full route
refresh. So in this case we request it internally.
Underlying (IGP) route may lead to PtP link, in this case it does not
need gateway. Which is different than direct route without gateway.
When recursive (BGP) route uses PtP route, it should not use recursive
next hop as immediate next hop, while for direct routes it should.